This setting forces the vectorization tools to prompt for a layer when thick raster selections are encountered. Click on the new range once to activate it, click on the.Note that the new range is set to accept wider lines. Click on the range once to activate it again, then click on the.Width Table, click on the new range once to activate it, then click on the Query Width and select a point in a utility line to determine its width in pixels.Įntity Width Information dialog box. When using the vectorization tools, the width of the raster selected is compared to the width table, and the layer is assigned based on these settings. This setting allows you to specify layers based on ranges of widths in pixels for raster linework. With this setting, lines detected as non-continuous will be placed on the easement lines layer. Override Width Table For Non-continuous Entities. This length is in pixels and can be selected on the screen using theĪutoCAD Raster Design toolset detects the presence of dashed or non-continuous linetypes. It can be used to jump over labels embedded in the line or to follow non-continuous lines such as dashed lines. This setting specifies the maximum length of a gap thatĪutoCAD Raster Design toolset will tolerate when following a raster polyline. Raster Entity Detection tab and change the If it is not, clickĬhange the raster entity detection settings In the \Tutorial6 folder, open the drawing file.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |